120
8024A–AVR–04/08
ATmega8HVA/16HVA
22. Voltage Regulator
22.1
Features
3.3V fixed output voltage
Automatic selection of Step-up or Linear Regulation depending on VFET voltage.
Fixed Linear Regulation mode can be selected for 2-cell applications
Battery Pack Short mode allowing large voltage drop at VFET without pulling VREG low.
22.2
Overview
The Voltage Regulator is a Combined Step-up and Linear Voltage Regulator. This allows the
same Voltage Regulator module to be used efficiently for a large range of input voltages.
A built in Charge-pump with external capacitors is combined with a linear regulator to keep a
constant output voltage for input voltages in the range 1.8 - 9.0V.
Figure 22-1 on page 121 shows the Voltage Regulator block diagram with external components
for combined Step-up and Linear mode. Figure 22-2 on page 121 shows the regulated voltage
VREG as a function of the input voltage VFET for 1-cell operation. When the VFET is sufficiently
high, the regulator switches automatically to linear operation. When VFET drops below a certain
level the regulator automatically switch back to step-up regulation. The different reset sources
during initialisation and shut down is also shown.
Figure 22-3 on page 122 shows the Voltage Regulator block diagram with external components
for Linear mode only, intended for 2-cell applications. In Linear mode only, the input voltage
range is 3.6 - 9.0V. In this case, no external fly capacitors are needed, and CF1N should be
grounded. Figure 22-4 on page 122 illustrates this operation.
In case of battery pack shortening, the voltage at the input of the regulator will drop quickly. If it
drops below minimum operating voltage, the voltage regulator can no longer supply internal or
external circuitry. However, the output voltage will not be pulled down by this incident, and the
external CREG capacitor can supply the circuitry for a time given by the size of the capacitor and
the total current consumption during the same period. VREG must stay above the Brown-Out
Threshold to avoid BOD reset. If a battery pack short occurs when VREG is equal to 3.3V and
the BOD level is 2.9V, the chip can continue operation for a time given by:
where I
AVG represents the average current drawn from CREG. For CREG = 2.2 F and
I
AVG = 100 A, this time equals 8.8 ms. The Voltage Regulator Monitor will detect if a short-circuit
has occured, allowing SW to minimize I
AVG.
When charging deeply over-discharged cells, the FET Driver will be operated in Deep Under-
Voltage Recovery (DUVR) mode. See “FET Driver” on page 136. In this mode a suitable voltage
drop is developed across the Charge FET to ensure proper operating voltage at the VFET pin.
This will ensure normal operation of the chip during 0-volt charging without setting the charger in
quick-charge mode before the cell has reached a safe cell voltage.
t
c
Δv
I
AVG
------------
CREG 0.4V
I
AVG
---------------------------------
==
相关PDF资料
ATSAM3N4AA-AU MCU FLASH 48-QFP
ATSAM3SD8CA-CU IC MCU 2X256KB CORTEX-M3 100-QFN
ATSAM3U1EB-CU IC MCU 64KB CORTEX-M3 144-TFBGA
ATSAM3X8EA-CU IC MCU 2X256KB CORTEX-M3 144-BGA
ATTINY12V-1SUR IC AVR MCU 1K FLASH 4MHZ 8-SOIC
ATTINY13-20SQR IC MCU AVR 1KB FLASH 20MHZ 8SOIC
ATTINY13A-MMUR MCU AVR 1KB FLASH 20MHZ 10DFN
ATTINY13V-10SUR MCU AVR 1KB FLASH 10MHZ 8SOIC
相关代理商/技术参数
ATMEGA8HVA-4CKUR 功能描述:8位微控制器 -MCU AVR 8KB FLSH 512B EE 1KB SRAM - 4 MHZ RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8HVA-4TU 功能描述:8位微控制器 -MCU AVR 8KB, 512B EE 4MHz 1KB SRAM 1.8-9V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8HVA-4TUR 功能描述:8位微控制器 -MCU AVR 8KB FLSH 512B EE 1KB SRAM - 4 MHZ RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8HVD-4MX 功能描述:8位微控制器 -MCU AVR 8KB, 512B EE 4MHz 1KB SRAM 2.1-8V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8L-8AC 功能描述:8位微控制器 -MCU AVR 8K FLASH 512B EE 1K SRAM ADC 3V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8L8AI 制造商:Atmel Corporation 功能描述:
ATMEGA8L-8AI 功能描述:8位微控制器 -MCU AVR 8K FLASH 512B EE 1K SRAM ADC 3V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA8L-8AJ 功能描述:IC MCU AVR 8K 5V 8MHZ 32-TQFP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器, 系列:AVR® ATmega 标准包装:9 系列:87C 核心处理器:8051 芯体尺寸:8-位 速度:40/20MHz 连通性:UART/USART 外围设备:POR,WDT 输入/输出数:32 程序存储器容量:32KB(32K x 8) 程序存储器类型:OTP EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4.5 V ~ 5.5 V 数据转换器:- 振荡器型:内部 工作温度:0°C ~ 70°C 封装/外壳:40-DIP(0.600",15.24mm) 包装:管件